Difference between Dc shunt motor and dc series Motor

-

 DC series motors and DC shunt motors are two types of DC motors that operate differently.

DC series motors are designed to have a high starting torque and are typically used in applications where the load is heavy or the speed needs to be controlled. They work by having the field winding and armature winding connected in series, which allows for a high starting torque. However, this also means that the speed of the motor is dependent on the load, as the more load there is, the slower the motor will run.

DC shunt motors, on the other hand, have field winding and armature winding that are connected in parallel. This means that the speed of the motor is not affected by the load, as the field winding and armature winding are not in series. However, DC shunt motors have a lower starting torque compared to DC series motors. They are typically used in applications where a constant speed is required, such as in fans or pumps.

Overall, the main difference between DC series motors and DC shunt motors is the way in which the field winding and armature winding are connected, which affects the starting torque and speed of the motor.

Comments

Post a Comment

Thank you for visiting😊

Popular posts from this blog

Using MOSFET Body Diodes to Charge Battery in Inverters

-
Image
  Using MOSFET Body Diodes to Charge Battery in Inverters In this post we try to understand how the internal body diodes of MOSFETs could be exploited for enabling the charging of battery through the same transformer which is being used as the inverter transformer. In this article we will investigate a full bridge inverter concept and learn how the in-built diodes of its 4 MOSFETs could be applied for charging an attached battery. What is a Full Bridge or H-Bridge Inverter In few of my earlier posts we have discussed  full bridge inverter circuits  and regarding their working principle. As shown in the above image, basically, in a full-bridge inverter we have a set of 4 MOSFETs connected to the output load. The diagonally connected MOSFET pairs are alternately switched through an external  oscillator , causing the input DC from the battery to transform into an alternating current or AC for the load. The load is normally in the form of a  transformer , whose low ...
Read more

Clipper Circuits

-
Image
  Clipper Circuits Electronic devices are very sensitive to  voltage . If a large amplitude voltage is applied, it may permanently destroy the device. So, it is essential to protect the electronics devices. The protection of the electronic devices can be achieved by using the clipper circuits. A clipper is a device that removes either the positive half (top half) or negative half (bottom half), or both positive and negative halves of the input AC signal. In other words, a clipper is a device that limits the positive amplitude or negative amplitude or both positive and negative amplitudes of the input AC signal. In some cases, a clipper removes a small portion of the positive half cycle or negative half cycle or both positive and negative half cycles. In the below circuit diagram, the positive half cycles are removed by using the series positive clipper. The clipper circuit does not contain energy storage elements such as  capacitor  but contains both linear and no-li...
Read more